Views: 0 Author: Site Editor Publish Time: 2023-12-02 Origin: Site
daily maintenance of packaging machinery, there are several procedures must be carried out. The cleaning, fastening, adjusting, lubricating and anticorrosion of the equipment. In the ordinary production process, the machine maintenance staff should: according to the machine packaging equipment maintenance manual and maintenance procedures, according to the prescribed cycle of strict implementation of the maintenance work, reduce the wear rate of parts, eliminate the hidden trouble that produces breakdown, extend the service life of the machine. Mechanical maintenance work: routine maintenance, regular maintenance and special maintenance. Regular maintenance can be divided into first-class maintenance, two-class maintenance and three-class maintenance, special maintenance can be divided into seasonal maintenance and maintenance two kinds of stop. The following article will be on the maintenance of these types of specific procedures and precautions are introduced. Packaging machinery routine maintenance to clean, lubrication, inspection and tightening as the center of gravity, in the work of the machine and after work should be required routine maintenance.
The first-level maintenance work is carried out on the basis of routine maintenance, the key work content is to lubricate, tighten and check the various parts and their cleaning work. The second level maintenance work takes the inspection, the adjustment as the key. Specific to check the engine, clutch, transmission, transmission components, steering and braking components. Three-level maintenance is to detect, adjust, remove the hidden trouble and balance the wear of the components. It is necessary to carry out the diagnostic test and condition check on the parts that affect the performance of the equipment and the parts with fault symptom, so as to complete the necessary replacement, adjustment and troubleshooting. Seasonal maintenance refers to the inspection and repair of components such as power system (engine) , conveying system (screw shaft and belt conveyor) , air pressure system (check Air compressor lubrication and seal) , and control system (repair of electromechanical control cabinet, which should be completed under the guidance of EUT after-sales engineers)